^,mi-c.onductoi ij^ , line. 20 stern ave. springfield, new jersey 07081 u.s.a. telephone: (973) 376-2922 (212)227-6005 fax: (973) 376-8960 STPS5L40 power schottky rectifier main product characteristics lf(av) vrrm tj (max) vf (max) 5a 40v 150c 0.44v features and benefits . negligible switching losses ? low forward voltage drop for higher efficiency. . low thermal resistance description axial power schottky rectifier suited for switch mode power supplies and high frequency inverters. packaged in do-201 ad, this device is intended for use in low voltage output for small battery chargers & consumer smps such as dvd and set-top-box.. do-201ad STPS5L40 absolute ratings (limiting values) symbol vrrm ip(rms) irav) ifsm tslg tj dv/dt parameter repetitive peak reverse voltage rms forward current average forward current surge non repetitive forward current storage temperature range ti = 100c 5 = 0.5 half wave, single phase tp = 10 ms maximum operating junction temperature * critical rate of rise of reverse voltage (rated vr, tj = 25"c) value 40 15 5 150 - 65 to + 1 50 150 10000 unit v a a a c c v/ns -- < thermal runaway condition for a diode on its own heatsink dtj rth(j a) nj semi-conductors reserves the right to change test conditions, parameter limits and package dimensions without notice. information furnished by nj semi-conductors is believed to.be both accurate and reliable at the time of going to press. however. nj semi-conductors assumes no responsibility for any errors or omissions discovered in its use. nj semi-conductors encourages customers to verify that datasheets are current before placing orders. quality semi-conductors
STPS5L40 thermal parameters symbol rthg-aj rth(j-l) parameter junction to ambient junction to leads lead length = 10 mm value 75 15 unit c/w c/w static electrical characteristics symbol ir* vf* parameter reverse leakage current forward voltage drop tests conditions tj = 25c tj=100c tj=125c tj = 25"c tj=100c tj= 125"c vr = vrrm if= 5 a min. typ. 8 25 0.44 0.40 0,38 max. 0.2 25 75 0.50 0.46 0.44 unit ma v pulse test: * tp = 380 fis, 8 < 2% to evaluate the maximum conduction losses use the following equation: p = 0.34 x |f STPS5L40 package mechanical data do-201ad plastic b 00 0d 0c 4 * ref, a b 0c 0d e dimensions millimeters min. 25.40 max. 9.50 5.30 1.30 1.25 inches min. 1.000 max. 0.374 0.209 0.051 0.049 notes 1 - the lead diameter 0 d is not controlled over zone e 2 - the minimum axial length within which the device may be placed with its leads bent at right angles is 0.59"(15mm)
|
