pj4800 series 700ma low dropout voltage regulators 1-6 2002/01.rev.a he series of fixed-voltage monolithic micr opower voltag e regulators is designed for a wide range of applications. t hes device excellent choice fo use in battery-power application. furthermore, the quiescent current increas es on slightly at dropout, which prolongs battery life. this series of fixed -voltage regul ators features very low quiescent current ( 100ma typ.) and very low drop output voltage (typ. 60mv al light load and 600mv at 700ma). this includes a tight initial tolerance of 0.5% typ., extremely good load and line regulation of 0.05% typ., and very low output temperature coe fficient. this series is offered in 3-pin to-263, to-220, to-252 & sot-223 package, and in 5-pin to-220 & to-263 package with shutdown input. ______________________________________________________________ ______________________________________ output accura cy within 2% at over timperature very low quiescent curr ent low dropout voltage (500mv typ) extremely tight load and line regulation very low temperatur e coe fficient unregulated dc input can withstand -20v reverse battery and +60v positive transients high-e ffi ciency linea r regulator battery powered systems portable instrumentation portable consumer equipment portable / palm top / notebook computers automotive electronics smps post-regulator device operating temperature packag e pj48xxcz-5l to-220-5l pj48xxcm-5l to-263-5l pj48xxcz to-220 pj48xxcm to-263 pj48xxcp to-252 pj48xxcw -20 to +85 sot-223 power dissipation internally limited lead temperature (soldering, 5 seconds) 260 storage temperature range .-65 to +150 operating junction temperature range -55 to +150 input supply voltage -20 to +35v continuous total dissipation at 25 free-air temperature to-220/to-263 to-252 sot-223 2w 1w 0.8w t features a pplications ordering info rmation to-220-5l to-263-5l sot-223 / to-252 to-220 / to-263 p in : 1 . e r r o r 2. input 3. g r ound 4. output 5. shutdown a bsolute maximum ratings p in : 1. i n p u t 2. g r ound 3. outpu t
pj4800 series 700ma low dropout voltage regulators 2-6 2002/01.rev.a parameter conditions min typ max units output voltage t j =25 full operating temperature 0.990|vo| 0.980|vo|| 5.0 / 3.3 1.010|vo| 1.020|vo| v output voltage 1ma i l 700ma, t j t jm ax 0.975|vo| 1.025|vo| v input supply voltage 26 v output voltaget emperature coe ffi cient (note 1) 50 150 ppm/ line regulation (note 2) 13v v in 26v (note 3) 0.1 0.4 % load regulation (note 2) 1ma i l 700ma 0.1 0.3 % dropout voltage (note 4) i l =100ma i l =400ma i l =700ma 200 400 500 300 600 700 mv mv mv ground current (note 5) i l =100 a i l =400ma i l =700ma 100 30 50 200 40 60 a ma ma dropout ground current (note 5) v in =vout-0.5v, i l =100 a 200 300 a current limit v out =0 700 900 ma thermal regulation (note 6) 0.05 0.2 %w output noise, 10hz to 100khz, i l =400ma c l =2.2 f c l =3.3 f c l =33 f 500 350 120 vrms adjust model reference voltage 1.21 1.235 1.26 v reference voltage over temperature (note 7) 1.185 1.285 v feedback pin bias current 20 40 na refer enc e voltage t emperature coefficient (note 1) 50 ppm/ feedback pin bias current t emperature coefficient 0.1 na/ shutdown input input logic voltage low (regulator on) high (regulator off) 2 0.7 v shutdown pin input current vs = 2.4v vs = 26v 30 450 50 600 a regulator output current in shutdown (note 8) 200 a note 1: output or reference voltage temperature coefficients defined as the worst case voltage ch ange divided by the tatal temperatur e range. note 2: regulations is measured at constant junction temperature, using pulse testing with a low duty cycle. changes in output voltage due to heating effects are cov ered under the speci fication for therm al regulation. note 3: line regulation is tested at 125 fo r i l = 5ma. for i l = 100 a and t j = 125 , line regulation is guaranteed by desigh to 0.2%. for 13v v in 26v. note 4: dropout voltage is defined as the input to output differential at which the output voltage drops2% below its nominal va lue measured at 1v differential. note 5: ground pin current is the regulator quiescent current. the total current drawn from the source is the sum of the ground pin current and output load current. note 6: thermal regulation is the change in output voltage at a time t after a change in power dissipation, excluding load or l ine regulation effects. specifications are for a 200ma load pulse(3w pulse) for t = 10ms. note 7: vref vou t (vin-1v), 2.3v vin 26v, 100 a i l 400ma, t j t jmax . note 8: 2v vshutdown, vin 26v, vout = 0v e lectrical charact eristics at vin = 14.4v, ta = 25 , i l = 5ma, c o = 100 f, unless otherwise noted.
pj4800 series 700ma low dropout voltage regulators 3-6 2002/01.rev.a fix ed regulator f or 3 pin adj / fix ed regulator for 5 pin b lock diagram and typical applications
pj4800 series 700ma low dropout voltage regulators 4-6 2002/01.rev.a
pj4800 series 700ma low dropout voltage regulators 5-6 2002/01.rev.a
pj4800 series 700ma low dropout voltage regulators 6-6 2002/01.rev.a
|
