s ? au57 200 1 -02-02 1 /3 toshiba rf power amplifier module s ? au57 uhf band ham fm rf power amplifier module hand ? held transceiver maximum ratings (tc = 25c) characteristic symbol rating unit dc supply voltage v dd 1 7 v dc supply voltage v gg 6 v input power p i 50 mw output power p o 1 2 w total current i t 3 a operating case temperature range t c (opr) ? 30~ 1 00 c storage temperature range t stg ? 40~ 11 0 c electrical characteristics (tc = 25c) characteristic symbol test condition min. typ. max. unit frequency range f range ? 430 ? 450 mhz output power p o 7 ? ? w power gain g p 25.4 ? ? db total efficiency t 40 ? ? % input vswr vswrin ? ? 3.0 ? harmonics hrm v dd = 9.6v v gg = 4v pi = 20mw z g = z l = 50 ? ? ? ? 25 dbc load mismatch ? v dd = 1 5v, pi = 20mw p o = 7w (v gg = adjust) vswr load 20: 1 all phase no degradation ? stability ? v dd = 7.5~ 11 .5v, v gg = 0~4v pi = 20mw vswr load 3: 1 all phase all spurious output than 60db below desired signal ? jedec ? eiaj ? toshiba 5 ? 23e weight: 3.5g unit in mm toshiba is continually working to improve the quality and reliability of its products. nevertheless, semiconductor devices in g eneral can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. it is the responsibi lity of the buyer, when utilizing toshiba products, to comply with the standards of safety in making a safe design for the entire system, a nd to avoid situations in which a malfunction or failure of such toshiba products could cause loss of human life, bodily injury o r damage to property. in developing your designs, please ensure that toshiba products are used within specified operating ranges as set forth in the most recent toshiba products specifications. also, please keep in mind the precautions and conditions set forth in the ?handlin g guide for semiconductor devices,? or ?toshiba semiconductor reliability handbook? etc.. 000707 eaa2
s ? au57 200 1 -02-02 2/3 caution this product has intersetting cap. please pay attention for exceeding stress and foreign matter in your application. and not to take away the cap. do not intermingle with normal industrial or domestic waste. this product is electrostatic sensitivity, please handle with caution. schematic test fixture the toshiba products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). these toshiba products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfun ction o r failure of which may cause loss of human life or bodily injury (?unintended usage?). unintended usage include atomic energ y control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion cont rol instruments, medical instruments, all types of safety devices, etc.. unintended usage of toshiba products listed in this docume n t shall be made at the customer?s own risk. the information contained herein is presented only as a guide for the applications of our products. no responsibility is assume d b y toshiba corporation for any infringements of intellectual property or other rights of the third parties which may result from i ts use. no license is granted by implication or otherwise under any intellectual property or other rights of toshiba corporation o r others. the information contained herein is subject to change without notice. 000707 eaa2
s ? au57 200 1 -02-02 3/3 caution these are only typical curves and devices are not necessarily guaranteed at these curves.
|
