|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
TC7MBD3245AFK TOSHIBA CMOS Digital Integrated Circuit Silicon Monolithic TC7MBD3245AFK Octal Bus Switch The TC7MBD3245AFK provides eight bits of high-speed TTL-compatible bus switching in a standard '245 device pinout. The low on-state resistance of the switch allows connections to be made with minimal propagation delay. The device is organized as one 8-bit switch. When output enable (OE) is low, the switch is on and port A is connected to port B. When OE is high, the switch is open and a high-impedance state exists between the two ports. The device is enable to realize the shift of signal level from 5 V to 3.3 V. All inputs are equipped with protection circuits against static discharge. Weight: 0.03 g (typ.) Features * * * * * * * * * Operating voltage: VCC = 4.5~5.5 V High speed: tpd = 0.32 ns (max) Low on resistance: RON = 5 (typ.) ESD performance: Machine model 200 V Human body model 2000 V Compatible with TTL outputs (control inputs) Low Power Dissipation: Icc = 10 A (max.) Package: VSSOP (US20) Pin compatible with the 74xx245 type. Functionally equivalent to (FST/CBT) 3245. Pin Assignment (top view) NC A1 A2 A3 A4 A5 A6 A7 A8 1 2 3 4 5 6 7 8 9 20 19 18 17 16 15 14 13 12 11 VCC OE B1 B2 B3 B4 B5 B6 B7 B8 GND 10 (top view) NC-No Internal Connection 1 2007-10-19 TC7MBD3245AFK Truth Table Inputs OE L H Function A port = B port Disconnect System Diagram A1 B1 A8 B8 OE Absolute Maximum Ratings (Note) Characteristics Power supply range DC input voltage DC switch voltage Input diode current Continuous channel circuit Power dissipation DC VCC/ground current Storage temperature Symbol VCC VIN VS IIK IS PD ICC/IGND Tstg Rating -0.5~7.0 -0.5~7.0 -0.5~7.0 -50 Unit V V V mA mA mW mA C 128 180 100 -65~150 Note: Exceeding any of the absolute maximum ratings, even briefly, lead to deterioration in IC performance or even destruction. Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook ("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Operating Ranges (Note) Characteristics Supply voltage Input voltage Switch voltage Operating temperature Input rise and fall time Symbol VCC VIN VS Topr dt/dv Rating 4.5~5.5 0~5.5 0~5.5 -40~85 Unit V V V C ns/V 0~10 Note: The operating ranges must be maintained to ensure the normal operation of the device. 2 2007-10-19 TC7MBD3245AFK Electrical Characteristics DC Characteristics (Ta = -40~85C) Characteristics Input voltage "H" level "L" level High-level output voltage (Note 2) Input leakage current Power off leakage current Off-STATE leakage current (switch off) Symbol VIH VIL IOH = -1 A VIS = VCC VIN = 0~5.5 V A, B, OE = 0~5.5 V A, B = 0~5.5 V, OE = VCC IIS = 64 mA VIS = 0 V ON resistance (Note 3) RON IIS = 30 mA Test Condition VCC (V) 4.5~5.5 4.5~5.5 4.75 5.0 5.25 4.5~5.5 0 4.5~5.5 4.5 4.75 4.5 4.75 4.5 4.75 5.5 5.5 Min 2.0 Typ. (Note 1) Max Unit V 0.8 3.2 3.4 3.6 1.0 1.0 1.0 A A A 2.3 2.5 2.7 2.8 3.0 3.2 VOH V IIN IOFF ISZ 5 5 5 5 35 35 9 8 9 8 65 50 10 2.5 A VIS = 2.3 V, IIS = 15 mA Quiescent supply current Increase in ICC per input ICC ICC VIN = VCC or GND,IOUT = 0 VIN = 3.4 V (one input) mA Note 1: Typical values are at VCC = 5 V, Ta = 25C. Note 2: It recommends that this device uses Pull-up resistance when adding and using resistance for an output terminal. Since it couses to drop a VOH voltage level when using Pull-down resistance for an output terminal. Note 3: Measured by the voltage drop between A and B pins at the indicated current through the switch. On resistance is determined by the lower of the voltages on the two (A or B) pins. AC Characteristics (Ta = -40~85C) Characteristics Propagation delay time (bus to bus) Output enable time Symbol tpLH tpHL tpZL tpZH tpLZ tpHZ Test Condition Figure 1, Figure 2 (Note) VCC (V) 4.5 Min Max 0.32 Unit ns Figure 1, Figure 3 4.5 7.0 ns Output disable time Figure 1, Figure 3 4.5 7.0 ns Note: The propagation delay time is calculated by the RC (on-resistance and load capacitance) time constant. Capacitive Characteristics (Ta = 25C) Characteristics Control pin input capacitance Switch terminal capacitance Symbol CIN CI/O OE = VCC Test Condition (Note) (Note) VCC (V) 5.0 5.0 Typ. 3 10 Unit pF pF Note: This parameter is guaranteed by design. 3 2007-10-19 TC7MBD3245AFK AC Test Circuit Open 7.0 V GND Measure CL = 50 pF RL = 500 CL RL Switch RL Parameter tpLH, tpHL tpLZ, tpZL tpHZ, tpZH Switch Open 7.0 V GND Output Figure 1 AC Waveform tr 2.5 ns Input (A, B) tf 2.5 ns 90% 1.5 V 10% 3.0 V GND VOH 1.5 V tpLH tpHL VOL Output (B, A) Figure 2 tpLH, tpHL tr 2.5 ns Output Enable ( OE ) tpLZ Output (A, B) Low to Off to Low tpHZ Output (A, B) High to Off to High Outputs enabled tf 2.5 ns 90% 1.5 V 10% tpZL 3.5 V 1.5 V VOL + 0.3 V VOH - 0.3 V tpZH VOL VOH 1.5 V GND Outputs disabled Outputs enabled 3.0 V GND Figure 3 tpLZ, tpHZ, tpZL, tpZH 4 2007-10-19 TC7MBD3245AFK VOH - VCC Characteristics (typ.) 4.5 Ta = 25C 4.0 (mA) (V) Ta = 25C 0 VOH IOH 3.5 High-level output voltage High-level output current 1A 100 A 6 mA 12 mA 24 mA -0.2 3.0 -0.4 2.5 -0.6 VCC=4.5V VCC=4.75V VCC=5.0V VCC=5.25V VCC=5.5V 2.5 3.0 3.5 4.0 5.0 2.0 -0.8 1.5 4.50 4.75 5.00 5.25 5.50 5.75 -1.0 2.0 Power supply voltage VCC (V) High-level output voltage VOH (V) 4.5 (V) Ta = 85C 4.0 (mA) Ta = 85C 0 VOH IOH 3.5 High-level output voltage High-level output current 1A 100 A 6 mA 12 mA 24 mA -0.2 3.0 -0.4 2.5 -0.6 VCC=4.5V VCC=4.75V VCC=5.0V VCC=5.25V VCC=5.5V 2.5 3.0 3.5 4.0 5.0 2.0 -0.8 1.5 4.50 4.75 5.00 5.25 5.50 5.75 -1.0 2.0 Power supply voltage VCC (V) High-level output voltage VOH (V) 4.5 (V) Ta = -40C 4.0 (mA) Ta = -40C 0 VOH 3.5 1A 100 A 6 mA 12 mA 24 mA IOH -0.2 3.0 High-level output voltage High-level output current -0.4 2.5 -0.6 VCC=4.5V VCC=4.75V VCC=5.0V VCC=5.25V VCC=5.5V 2.5 3.0 3.5 4.0 5.0 2.0 -0.8 1.5 4.50 4.75 5.00 5.25 5.50 5.75 -1.0 2.0 Power supply voltage VCC (V) High-level output voltage VOH (V) Figure 4 5 2007-10-19 TC7MBD3245AFK Package Dimensions Weight: 0.03 g (typ.) 6 2007-10-19 TC7MBD3245AFK RESTRICTIONS ON PRODUCT USE * The information contained herein is subject to change without notice. 20070701-EN GENERAL * TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the "Handling Guide for Semiconductor Devices," or "TOSHIBA Semiconductor Reliability Handbook" etc. * The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury ("Unintended Usage"). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his document shall be made at the customer's own risk. * The products described in this document shall not be used or embedded to any downstream products of which manufacture, use and/or sale are prohibited under any applicable laws and regulations. * The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patents or other rights of TOSHIBA or the third parties. * Please contact your sales representative for product-by-product details in this document regarding RoHS compatibility. Please use these products in this document in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses occurring as a result of noncompliance with applicable laws and regulations. 7 2007-10-19 |
Price & Availability of TC7MBD3245AFK07 |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |